Precautions For Making Stainless Steel Pipe Fittings

In the processing of Sanitary Valve, when the tapping thread reaches the size, the two tap end faces may touch each other because the tap bottom is long. In this case, the end face of the tap needs to be shortened, but the short end grinding may have an adverse effect on the function of the tap.

The contact between the front and rear taps of the tap end face and the workpiece to be processed can be seen. After shortening the end face, the threaded part of the tap cannot be introduced into the hole normally, but is pressed into the hole by the end face, which affects the function of the tap.

In order to solve these problems, consumers must stop grinding the front guide plate of the tap and repair the front guide plate of the front and rear taps. Since the shape of the front guide plate has changed after grinding, it still affects the function of the tap. The solution to this problem is a furnace rolling mill: the furnace rolling mill includes a reciprocating rough rolling mill and a four-roll reciprocating finishing mill. Two hot rolling mills are installed on the conveyor line on both sides of the finishing mill.